Tooth shape:single cut
Head material:Tungsten carbide
Shank material:Steel
Shape:inverted cone shape.Any other shape
you need available
We manufacture and specialize in Carbide rotary burrs and files die grinder bits, all made right here in China.
What is Carbide rotary burrs and files ?
Tungsten carbide burr,carbide rotary burrs and files often referred to as rotary files or die grinder bits are used for cutting, shaping, and grinding, and for the removal of sharp edges, burrs and excess material (deburring).
Helpful notes: For drilling holes in hard metals you would need to use carbide micro drills or carbide straight shank drills. For cutting slots, routing, profiling, contouring, counter-boring, and reaming you would use a a carbide end mill, carbide slot drill or a carbide router. For cutting and shaping stone or glass you would use a Diamond Burr.
The Advantages of Carbide rotary burrs?
Long life
Use for long production runs
High stock removal
Ideal for using on many hard and tough materials
Ideal for Deburring, finishing, carving, shaping and smoothing welds, moulds, dies and forgings
Carbide rotary burrs and files are Harder than HSS Burrs.
Good quality Carbide rotaty Burrs are machine ground from a specially chosen grade of carbide. Due to the extreme hardness of the Tungsten Carbide they can be used on much more demanding jobs than HSS (High Speed Steel).
Carbide rotaty Burrs also perform better at higher temperatures than HSS so you can run them hotter, for longer.
HSS burrs will start to soften at higher temperatures so carbide is always a better choice for long term performance.
Head diameter:
Metric Units:3,6,8,10,12,16,19,22,25.
Imperial Units:1/8’,5/32’,3/16’ ,1/4’,5/16’,3/8’,7/16’,1/2’,5/8’,3/4’,7/8’,1’.
Shank Diameter:3mm or 6mm or 1/4’or 1/8’ or long shank 150mm,also can be designed as customer’s request.
Application:
Double cut carbide rotary burrs tend to be used on ferrous and non ferrous metals, aluminium, soft steel and also for all non-metal materials such as plastics and wood. They have more cutting edges and will remove material faster. These are the most popular cut and will see you through most applications.
Double cut are sometimes referred to as Diamond Cut or Cross Cut (2 flutes cut across each other) . They will leave a smoother finish than single cut due to producing smaller chips as they cut away the material. Use for medium-light stock removal, deburring, finishing and cleaning.
Medium- light removal of material
Deburring
Fine finishing
Cleaning
Smooth finish
Creates small chips
What Speed or RPM should you use your Carbide rotary burrs?
The speed at which you use your carbide rotary burr in your rotary tool or die grinder will depend on the material you're using it on and the contour being produced, but it's safe to say you do not need to exceed speeds of 35,000 RPM. The table below
shows some approximate speeds.
Helpful note: If the burs are chipping easily this could be due to the speed being too slow. However, it's ideal to start the cutting slow, increasing the speed as you go along. High speeds will prevent clogging in the flutes of your burrs.
Diameter of Burr RPM
3mm or 1/8" 17,000 - 26,000
6mm or 1/4" 11,000 - 16,500
12mm or 1/2" 8,000 - 12,000
16mm or 5/8" 7,650 - 11,500
E-mail: sales@ztcarbide.com
Add: No.1 of Longxin international building, No.255 of Tongxia Road,Shi Feng District, Zhuzhou Hunan Province,China
We chat